Call (980) 478-8030

Commercial Freezer Repair in Charlotte, NC

Freezers fail quietly — the coil ices over, the fan stops, the box creeps from 0°F to 20°F overnight. We diagnose and fix reach-in, undercounter, chest and display freezers before you lose inventory.

Freezers repair Charlotte

What we fix

  • Freezer not cold enough or thawing product
  • Frozen-solid evaporator coil (defrost heater, termination sensor, controller)
  • Drain line heater failures and ice on the floor
  • Evaporator and condenser fan motors
  • Door gaskets, hinges and door heater wires
  • Refrigerant leaks and compressor replacement

How a service call works

  1. Call or send the form — tell us the brand, model and any error code.
  2. We confirm a time window, same day whenever possible.
  3. The technician diagnoses the unit and gives you a written estimate.
  4. You approve; we repair on the spot or return with the part.
  5. You get a service report with temperatures and parts used.

Request service

We call you back to confirm the time. For emergencies call (980) 478-8030.

Common problems we fix

SymptomUsual causes we check
Running but not coolingDirty condenser coil (most common), condenser fan failed, iced evaporator (defrost failure), evaporator fan failed, low charge/leak, failed start relay/compressor.
Too warm / high temp alarm (HA, A01, Er 7, tHi)Door left open or not closing, torn gasket, overloaded with warm product, blocked air vents, dirty condenser, defrost problem.
Freezing product (cooler)Thermostat/setpoint too low, failed probe, insufficient clearance, controller fault.
Iced-up evaporatorDefrost heater, defrost termination sensor (P2/E2), defrost timer/controller, door gasket letting in humid air.
Water on floor / insideClogged drain tube, frozen drain line (freezer, failed drain heater), condensate pan heater/float.
Runs constantly / short cyclingDirty condenser, gasket leaks, low charge, bad probe, oversized load, ambient too hot.
Compressor won't start / clickingStart relay/capacitor, overload, low voltage, failed compressor.
Probe error (P1/P2/E1/E2/E29)Ohm the NTC probe vs. chart, inspect connector/wiring for water intrusion, replace probe, then controller.

Brands we service

Error codes for this equipment

Look up what the display is telling you:

Dixell

P1 P2 P3 P4 HA LA HA2 / LA2 dA EA / EAL CA / BAL PAL EE rtc

Danfoss

A01 A02 A99 E27 E29 E30

Delfield

E-1 E-2 E-6 E-13 Er 1 / Er 5 Er 2 Er 3 Er 4 Er 6 Er 7 E01 E02 Lo / Hi LEA

Continental Refrigerator

E0 E1 E2

True

E1 E2 E3 tHi / HA tLo / LA do P1

Beverage-Air

dEF Hi Lo Con dor / dOr uHi / uLi LEA E01–E04

Traulsen

CLN-FIL dEF AL

Turbo Air

Alarm light Door Open light Defrost light

Carel

rE E0 E1 E2 / E3 / E4 LO HI AFr IA CHT / cht dor Etc EE / EF

Serving the Charlotte area

Commercial Freezer Repair in Charlotte, Concord, Gastonia, Huntersville, Matthews, Mint Hill, Cornelius, Davidson, Mooresville, Kannapolis, Harrisburg, Monroe, Indian Trail, Pineville, Belmont, Mount Holly, Fort Mill, SC, Rock Hill, SC, Tega Cay, SC, Lake Wylie, SC.

Equipment down right now?

Same-day commercial service across the Charlotte area · Open 7 days · 7:00 AM – 10:00 PM

📞 Call now